It worked! Thank you so much. Last time I tested change of drives I didn’t make restart - newbie in Linux thank you so much for help!
BTW for awesome work on all.modukes - is there way for donate?
It worked! Thank you so much. Last time I tested change of drives I didn’t make restart - newbie in Linux thank you so much for help!
BTW for awesome work on all.modukes - is there way for donate?
Keywords are defined in wiki page EXT-Detector. There are two providers - Porcupine which is paid since last update and snowbound which is free. https://wiki.bugsounet.fr/en/EXT-Detector
You always need a gateway If I am right according to wiki
It worked! Thank you so much. Last time I tested change of drives I didn’t make restart - newbie in Linux thank you so much for help!
BTW for awesome work on all.modukes - is there way for donate?
I tried this with no change - still don’t work. May VNC or some other setting prevent screen from sleep?
Keywords are defined in wiki page EXT-Detector. There are two providers - Porcupine which is paid since last update and snowbound which is free. https://wiki.bugsounet.fr/en/EXT-Detector
Hello,
at the start I want to thak you for all the modules that you created! I am finishing my mirror now and I got problem with Ext-Screen.
My monitor is connected through HDMI cable.
I set module correctly (I hope) and after time interval screen go blanc but it will remain turned on. I tried every single mode and the result is the same. I also tried to change driver with no luck.
Here is my config for mode 2:
{
module: 'EXT-Screen',
position: "bottom_right",
config: {
debug: false,
animateBody: true,
delay: 1 * 60 * 1000,
turnOffDisplay: true,
mode: 2,
ecoMode: true,
displayCounter: true,
displayBar: true,
displayStyle: "SemiCircle",
displayLastPresence: true,
lastPresenceTimeFormat: "LL H:mm",
detectorSleeping: false,
autoHide: true,
delayed: 0,
gpio: 20,
clearGpioValue: true,
sound: false
}
},
Result:
[04.04.2023 20:57.56.172] [ERROR] [SCREEN] Error: Command failed: DISPLAY=:0 xset q | grep Monitor
I also tried mode 1 with no errors in output.
Thank you for help