Solved EXT-Screen.js file keeps reverting to default values
-
@bugsounet said in EXT-Screen.js file keeps reverting to default values:
ah … are you really sure of your configuration !? (not me)
maybe some times wiki can helpI repeat again…
After if you prefer…- Your config is TOTALY wrong…
- COPY SAMPLE CONFIG of the wiki and retry
- You Don’t have to edit main core file
-
Oh, ok. The Wiki page shows the two versions (minimal configuration and personalized configuration). I thought that I could just pick and choose some of the lines. The note indicated “Don’t copy/past the entire default config, just add in default config your needed new change value !”. I will copy the sample file and edit the values I need and post the results. Thanks!
-
now that you see the default personlized config …
Are you really sure that your config :
{ module: 'EXT-Screen', position: 'bottom_left', configDeepMerge: false, config: { screen: { delay: 2 * 60 * 1000, mode: 4, .... }, } }
is the same like this ???
The personalized default config :{ module: 'EXT-Screen', position: 'top_left', config: { debug: false, animateBody: true, delay: 2 * 60 * 1000, .... } },
That’s why … I say … your config is really wrong
All of your value inscreen:{}
are ignored -
Yes, I see the problem… but not sure what happened here. I’ve been using my configuration for quite awhile now, so I didn’t think that there was any issue with my configuration file. I was able to observe the mode change in the EXT-Screen.js file, which was what was confusing me. I have made the correction, so I am anticipating that the problem has been resolved. Thanks very much for the assistance!
-
ok, right, i keep this topic open
Let’s confirm in a couple of days !
Note: I have to do some update in a couple of days for
EXT-Screen
-
Ok. Thanks. I will update when available, and continue to monitor the reboots…
-
see
/boot/config.txt
file
the response is inside -
enable:
# uncomment to increase signal to HDMI, if you have interference, blanking, or # no display config_hdmi_boost=4
replace:
dtoverlay=vc4-kms-v3d
by
dtoverlay=vc4-fkms-v3d
note: it’s a system file!
so usesudo nano /boot/config.txt
when saved reboot your pi
-
Ok. Changes made… thanks.
-
It’s better?
-
So far, so good.
-